
How to Replace Wing Mirror Hinge on Suzuki Vitara LY 2015-2020
When the customer first bought this car, he noticed that the driver's rearview mirror turn signal had slight scratches and cracks, and the rearview mirror was shaking up and down. Although the amplitude was not large, sometimes there would be resonance noise when walking on rough cement roads. At that time, the customer could not diagnose whether it was a hinge problem or another problem, and was unwilling to replace the assembly. Therefore, he put a rubber pad in the gap and gradually put it aside until this year's Double Eleven promotion. The customer purchased our product and shared the installation process:
KIBOWEAR's Hinge:

When I first bought this car, there were small bumps and cracks here, and I used UV glue to fix them.

Just shake up and down like this.

There is a large gap when shaking here. I'm just stuffing the rubber here

open and disassemble ↓
High pitched hood, an expansion buckle

Two plugs and three screws can be used to remove the rearview mirror assembly.

8 barbed structures. The rearview mirror can be separated

Separate the heating wire of the rearview mirror

The red circle is a three-point barbed structure with a decorative cover in front of the pipe. Yellow arrow 4 screw tube back cover. (Previously, the barbed structure was dismantled and glued with AB adhesive, please ignore it)

Remove the mirror cover

Remove Inner Frame

Remove the lens angle adjustment mechanism plug

Remove turn signal light plug

Wire harness overview

Pull open the anti retraction structure of the plug

Remove the terminals and insert this pile of wires into the shaft.

Use pliers to press down first, then rotate counterclockwise by 45 degrees, and the hinge will pop out

The cause of the malfunction has been identified, it was caused by a collision and one of the teeth was damaged.

The teeth are broken, causing the rearview mirror to sway up and down

Bottom looks like this below

Compare the old OEM hinge and new KIBOWEAR hinge

Try it out. Is it suitable or not

Preparing to install a new Hinge

As usual, apply lubricating grease first

Apply a layer on top as well

First, insert the wire into the shaft without protruding.

Then press down with the vise and rotate clockwise 45 degrees to complete the installation of the new hunge
Pull out the wiring harness from the new hinge

After resetting the terminal, plug it back into its original position.

Now the gap is much smaller than before

Now mirror assembly shaking disappeared.

Shop Related Parts
Replacement side mirror parts that fit the vehicles covered in this guide.


