Upgrade Auto-dimming Mirror Glass Mercedes Benz GLB C S G E-class W205 W222 W213 W238 X205
Installation Guides

Upgrade Auto-dimming Mirror Glass Mercedes Benz GLB C S G E-class W205 W222 W213 W238 X205

KIBOWEAR Technical TeamNovember 17, 2026

Before:

After:

Many people don't know the principle of Auto-Dimming Wing Mirror Glass, thinking that just replacing the lenses is enough, but it's not that simple. Auto-dimming glass requires power and a controller. Since this controller is in the anti glare inner mirror of the car, only when the inner mirror detects the high beam behind and sends a command to the outside rearview mirror, will the outside rearview mirror change color. So, the first step in installation is to replace the original interior rearview mirror:

The first step is to remove the cover of the rain sensor. This step is not difficult, just remove the small decorative panel in the middle first, and the entire cover can be removed. Then unscrew the interior rearview mirror counterclockwise. When dismantling the rearview mirror inside the car, be careful not to forcefully dismantle it. Pay attention to the technique, as violent dismantling may cause the windshield to explode.

After removing the original car's interior rearview mirror, we installed aftermarket inner rearview mirror with auto-dimming function. Because the power of inner rearview mirror is extremely low and does not consume much electricity, we combined its power supply with the DVR. (Many Mercedes Benz models have fuse boxes located on the front passenger's foot slope, including the GLB.)

Thread the wire through the roof and A-pillar, and walk to the door panel.


Remove the original car door panel. The GLB door panel only has two screws, making it relatively easy to disassemble.

I really enjoy installing this car with door panel wiring. Apart from the easy disassembly of the door panels, the wiring is also simple because it is a pipe that can be directly threaded through, which is much more convenient than terminals at door panels such as Audi and Toyota

Remove the original wing mirror glass lens and extend power cable from inner rearview mirror onto external wing mirror

Now connect new KIBOWEAR Auto-dimming mirror glass:

We noticed that the automatic anti glare lens has an additional set of wires on the back compared to regular lenses, which is the wiring for the anti glare function.

This is a normal working state (no high beam detected)

Illuminate the sensor of the endoscope with light, and the color of the lens begins to darken

The final effect. When there is high beam illumination behind, the lenses will darken, so the rearview mirror will not be glaring. When the high beam disappears, the original white mirror will be restored.

Shop Related Parts

Replacement side mirror parts that fit the vehicles covered in this guide.

Related Articles